Visible Light Communication using PURPLE board
GPL-3.0 License
This repository contains hardware and software for building practical Visible Light Communication system. The PURPLE board is a cape that works with BeagleBone Black embedded computer. With PURPLE, one can send and receive information using visible light.
The hardware design is available in the eagle folder.
This directory contains all configuration files used before make.
This directory contains all documents and notes used as instructions and tutorials deployed in class.
This directory contains the userspace program to send and receive msgs through light.
This directory contains the binary files that's going to run on PRU
This directory contains the hardware schematic and the PCB layout as well as the partlists.
This directory contains the source file that needs to be compiled into the binary file under firmware folder.
This directory contains the test and debugging file in user space for the PRU source code.
Step 1: Insert SD card to BBB board. Make sure SD card has been flashed with the purple image.
Step 2: Boot Up the BBB board and connect the board to your PC/Laptop. Make sure you have successfully installed the drivers for BBB.
Step 3: SSH to the board. ssh [email protected]
ssh [email protected]
Step 4: When you login, Change to root.
sudo -s
Step 5: Go to purple repository.
cd purple
Step 6: Reload the pru remoteproc kernel module.
rmmod pru_rproc
modprobe pru_rproc
Step 7: Compile the code.
make clean
make
Step 8: Make sure the code got compiled succesfully.
Step 9: Start listening on incoming messages on one purple board.
cd example
./receive
Step 10: Start sending the messages on other purple board.
cd example
./send "hello world"
Step 11: Make sure the message got received correctly.
Step 12: Congratulations. You've completed this short tutorial.