Momera
A program that extracts the motion from your camera.
Introduction
This is a program that I made using python, because I was interested on motion extraction (after watching Posy's excellent video)
Installation
This program is very easy to setup.
-
Using Git:
git clone https://github.com/ctih1/Momeracd Momerapip install -r requirements.txtcd srcpython3 main.py
Usage
If you do not want to alter any settings, you can skip this section. If have issues, like the program using the wrong camera, you should follow this guide
| Key | Action |
|---|---|
| Q | Quit the application |
| H | Disable motion extractor to see the input video |
| K | Change camera (left) |
| L | Change the camera (right) |
| Mousewheel Up | Alter the frame delay by +1 |
| Mousewheel Down | Alter the frame delay by -1 |
| Enter | Enter change resolution mode, type using your keyboard, then hit enter to apply (WIDTHxHEIGHT@FPS) (ex: 1920x1080@30) |
Notifications
You may see some notifications when doing actions, or when getting errors. They are pretty self-explanatory, but on some errors, it might be hard to find a cause. Here's the most common one:
Failed camera switch #x
There are two reasons why this might happen:
- This camera doesn't exist.
- The camera's width or height is listed as 0