Use and configure your vap11g device with this open source tool
GPL-3.0 License
The goal of this project is to allow you to use and configure your vap11g device with your FREE and open source operating system, it may be possible to use it with slight modifications w/ ANY OS available.
Software:
Hardware:
Clone this repository: git clone https://github.com/philsmd/vap11g.git
Run it: cd vap11g sudo ./vap11g.py
USAGE: sudo ./vap11g.py [OPTIONS]
where the available [OPTIONS] are: -i network interface (e.g. eth0, eth1, p4p1, en0) -d debug mode -v verbose mode (more verbose than debug, with packet inspection) -c channel number to be set (NOT the channel on which the device should scan) -s ESSID, network name -n noauth -w WEP -p WPA -a WPA2 -k network key, passphrase, password for your security protocol (e.g. WPA2-PSK passphrase) -t use 128bit WEP, strong mode -m disable mac address filtering (only used for finding/filtering the local connected ethernet device)
Credits go to:
This project is lincensed under the GNU GENERAL PUBLIC LICENSE version 3. SEE LICENSE file
The script/software does not intend any kind of reverse engineering or other illegal use of the hardware or software of the manufacturer etc. The protocol (I have discovered when writing this README) was already in the public domain for a while, the whole packets-exchange was already known and published on wikis and websites.
This software only does SEND the (almost) same packets that anyway are available on the LAN (ethernet) cable AND that you can capture (legally) with any OPEN SOURCE and FREE tool intended for this purpose.
USE IT AT YOUR OWN RISK
You can not claim any responsibility for any damage, malfunction, problems to the author. Use this software if you trust the author. Trust the author!