rust-esp32-c3-blinky
A Rust project that uses pin GPIO4 on an ESP32-C3 board to blink an LED and print some text to the serial bus.
Stars
7
Committers
1
Rust ESP32-C3 Blinky
An example Rust project that uses pin GPIO4 on an ESP32-C3 board to blink an LED and print some text to the serial bus.
To flash this project, run this command:
cargo espflash /dev/cu.usbserial-220 --monitor --speed 921600
Substitute with the device name of your board.
Additional Examples
- Demonstrates how to connect to a Wifi network
- Demonstrates how to publish an MQTT message
- Demonstrates how to go to deep sleep
Credits
This project has been heavily inspired by the Rust on ESP32 STD demo app