Python library for BusPirate
OTHER License
Python library for BusPirate based on code from Garrett Berg. It tries to be more Pythonic than the original code.
This library allows using the following modes:
For more information about the BusPirate see http://dangerousprototypes.com/docs/Bus_Pirate
Based on code from Garrett Berg [email protected] (http://dangerousprototypes.com/2011/03/14/new-version-of-pybuspiratelite-python-library/)
Note: Python 3.6 is required, mainly due to the use of f
-strings.
from pyBusPirateLite.SPI import SPI
spi = SPI()
spi.pins = SPI.PIN_POWER | SPI.PIN_CS
spi.config = SPI.CFG_PUSH_PULL | SPI.CFG_IDLE
spi.speed = '1MHz'
# send two bytes and receive answer
spi.cs = True
data = spi.transfer( [0x82, 0x00])
spi.cs = False
from pyBusPirateLite.BitBang import BitBang
bb = BitBang()
bb.outputs = bb.PIN_AUX
bb.pins = 0 # set aux pin = 0
bb.pins = bb.PIN_AUX # set aux pin = 1
from pyBusPirateLite.I2C import I2C
i2c = I2C()
i2c.speed = '400kHz'
i2c.configure(power=True)
i2c.write_then_read(2,0, [0xec, 0xf6]) # set write register
i2c.write_then_read(1,1,[ 0xed]) # read from register
from pyBusPirateLite.BitBang import BitBang
bb = BitBang(connect=False)
port = bb.get_port()
print(port)
bb.connect()